Tv stand that hides tv trial#
Tv stand that hides tv tv#

The Spruce Home Improvement Review Board.

Start by attaching the second set of hinges to each outside of the box first. Lay the box flat on the ground facing up. Mostly because it was midnight when we were trying to figure this out, but Trent and I sat there for a few minutes thinking this through. You will need two people to get this job done properly. It's just a bit darker, but you really can't notice it. In all honesty, our wood isn't a perfect match to our frames.

Tv stand that hides tv trial#

It's truly about trial and error holding up the frames to the stain many different times. We took a few days to apply a few coats of stain to get the look we wanted. To get a good match, try sanding the stain down a bit and wiping it with a damp cloth. Wood does pick up different parts of the stain and sometimes you have to either apply less or more depending on what's happening. How do you get the stain to match the frames? I'll explain how we hung the cabinet later.įor my box to match my weathered wood picture frames, I used Weathered Gray stain and antiquing glaze. You can see the lower support beam pictured below. It will also help to keep your box square.Īttach the beam by nailing or screwing it into the sides as well as the top or bottom piece. Next you will need to add two boards on the inside of the box.Īdding a support pieces across the top and bottom of the box makes able to hang it into a stud. Once assembled, you should have a big, square box. We used a pneumatic nail gun for a quick an easy build, but you could use 1 inch pocket screws for this as well.

Tv stand that hides tv tv#

There will likely be an inch gap or more between your TV and the wall cabinet. NOTE: This will not be a tight fit around your TV. This gives your DIY doors a frame to sit against. Remember the measurement you took of your finished doors?Ĭut your wood the width and height of your finished doors - not the width and height of your TV. Here are some of my favorite DIY must-have tools I recommend.

This is super simple, but you need a miter saw or circular saw. Take into account the measurements of the TV mount. Next you want to measure the depth of your TV. I ordered eight 11 x 14 frames to cover the entire TV. To cover the entire TV, I took the measurements from Michaels and made sure the picture frames would work. This may also mean you need to find smaller or larger picture frames. Please Note: This tutorial is for a 43 inch TV, so you will have to adjust and customize the measurement for your screen size. Ours is a 43 inch TV measuring at 38 x 22. You want to measure the height and width of your TV to determine the size of picture frames you'll need. The cabinets that hid just the TV run from $250 for a small TV to $1500 - way too expensive for our tight budget. I had been looking for solutions to hide our electronic devices and there are plenty of storage cabinets and tv consoles out there. That gave me the idea to build this cabinet. It was an end of the year clearance sale email from Michaels for their picture frames at 70% off if you ordered in bulk.

4 Piano Hinges - ours were 30 inches long.

Stain - I used Weathered Gray and Antiquing Glaze.

Wood to fit the depth of your TV - we used 1 x 6 Pine Boards.

Picture frames that fit the size of your TV - I ordered these from Michael's in 11x14.

(Some affiliate links are provided below.

STEP FOUR: Attach your doors to your box.

How do you get the stain to match the frames?.

STEP THREE: Build and stain your cabinet.